Understanding Voltage and Current

Voltage is the electrical push that drives charge around a circuit. Current is the rate at which that charge flows. One is measured in volts, the other in amperes.

The water analogy

A common way to picture a circuit is water in pipes. Voltage is like the pressure from a pump or a raised tank. Current is like the flow rate, the volume passing each second. Resistance is like a narrow section of pipe that restricts the flow. More pressure pushes more flow through the same restriction.

The analogy is not perfect, but it captures the key idea: voltage exists between two points whether or not anything flows, and current only flows when there is a complete path.

The definitions

  • Voltage: energy per unit of charge. One volt is one joule per coulomb.
  • Current: charge per unit of time. One ampere is one coulomb per second.
  • Resistance: how much voltage is needed per unit of current. One ohm is one volt per ampere.

The three are tied together by Ohm's law, V = I × R. The guide to electrical resistance covers it in detail.

Power: volts times amperes

power (W) = voltage (V) × current (A)

The same power can be delivered as high voltage with low current or low voltage with high current. That trade-off shapes the whole electrical world.

ExampleVoltageCurrentPower
Basic USB charger5 V1 A5 W
Fast phone charger9 V2.2 A20 W
Laptop USB-C charger20 V3.25 A65 W
Kettle (230 V country)230 V10 A2,300 W
Kettle (120 V country)120 V12.5 A1,500 W

Why power lines use high voltage

Heat lost in a cable is proportional to the square of the current. Sending power at a higher voltage needs less current, so far less is wasted. Transmission lines run at hundreds of kilovolts for that reason, and transformers step the voltage down near homes.

AC and DC

Batteries supply direct current, which flows one way. Mains supplies alternating current, which reverses 50 or 60 times a second. A mains voltage of 230 V or 120 V is an effective (RMS) value, the steady DC voltage that would deliver the same heating power. The peak is about 1.41 times higher.

Choosing a charger

The voltage must match what the device expects. The current rating of the charger is a maximum it can supply, and the device draws only what it needs, so a charger with a higher current rating at the correct voltage is fine. Battery capacity in mAh is charge, not energy: multiply by voltage to compare batteries of different types.

Frequently asked questions

Is it voltage or current that is dangerous?

Current through the body does the harm, but it takes voltage to drive that current through the body's resistance. Both matter, which is why mains voltages must be treated with care and low-voltage circuits are generally safer to touch. This is general information, not safety advice for any specific installation.

How do I convert amps to watts?

Multiply the current in amperes by the voltage in volts. Five amperes at 12 volts is 60 watts.