How to Estimate Body Fat Percentage With the US Navy Tape Method
Body fat percentage describes how much of your weight is fat. It is more informative than BMI for many people, but it is hard to measure exactly. A tape measure and the US Navy method give a practical estimate at home.
What the method uses
The US Navy circumference method estimates body fat from height and a few tape measurements: neck and waist for men, with hips added for women. It was developed to screen military personnel without special equipment. The calculator uses the metric version of the published equations, where all measurements are in centimetres.
How to measure correctly
- Use a flexible, non-stretch tape and keep it level and snug but not compressing the skin.
- Neck: measure just below the larynx (Adam's apple), with the tape sloping slightly down at the front.
- Waist: for men, at the navel; for women, at the narrowest point of the waist. Measure after a normal breath out, without pulling in your stomach.
- Hips (women): around the widest part of the buttocks.
- Take each measurement two or three times and use the average, ideally at the same time of day.
Worked examples
Man, 175 cm, neck 38 cm, waist 85 cm: the estimate is about 16.9%. Woman, 165 cm, neck 32 cm, waist 75 cm, hips 98 cm: about 28.9%. Results move noticeably with small measurement differences: a 2 cm change in waist can shift the estimate by about two percentage points.
Typical category ranges
| Category | Men | Women |
|---|---|---|
| Essential fat | 2 to 5% | 10 to 13% |
| Athletes | 6 to 13% | 14 to 20% |
| Fitness | 14 to 17% | 21 to 24% |
| Average | 18 to 24% | 25 to 31% |
| Higher | 25% and above | 32% and above |
These ranges follow the commonly cited American Council on Exercise categories. Women naturally carry more essential fat than men because of reproductive and hormonal needs. Healthy ranges also shift with age, and being at the lowest end is not a goal for most people.
How accurate is it?
Tape-based formulas generally have an error of several percentage points compared with laboratory methods such as DEXA scans. They are best for tracking change over time with the same technique rather than as an exact value. If your waist falls and your neck stays similar, the estimate falls, which usually reflects a real change in body composition.
BMI-based estimate
The calculator also shows an estimate derived from BMI, age and sex. That approach is less accurate for an individual because BMI cannot separate muscle from fat, so give more weight to the circumference method.
Common mistakes
- Measuring over clothing or on a full stomach.
- Pulling the tape tight or letting it sag.
- Mixing inches and centimetres.
- Comparing results from different methods and treating the differences as real change.
Using the result
If your number is high or low, or you have concerns about your weight, discuss them with a healthcare professional. They can combine body fat with waist size, blood tests and your history. Good habits matter more than any single measurement.
Frequently asked questions
Why does the calculator say waist must be larger than neck?
The formula uses the difference between the two. If the waist is not larger than the neck, the logarithm is undefined and the measurement is probably an error.
How often should I measure?
Every two to four weeks is enough. Daily fluctuations from water and food are larger than real changes in fat.
Is a lower body fat always healthier?
No. Very low body fat can disrupt hormones, bone health and immunity. The goal is a healthy range, not the lowest number.
Keep reading
- Use the Body Fat Calculator
- BMI Calculator: guide
- BMR Calculator: guide
- Ideal Weight Calculator: guide
- Calorie Calculator: guide
This guide is general information, not medical advice, diagnosis or treatment. Talk to a qualified healthcare professional about your own situation. See our disclaimer.