Running Pace Explained: Convert Pace and Speed, and Predict Race Times

Last updated October 3, 2026 · How we calculate and check results

Pace is how long it takes you to cover a unit of distance. It is the number runners use to plan training and races, and it is easy to calculate and convert once you know the three relationships between distance, time and pace.

Open the Pace Calculator

The three relationships

Pace = time ÷ distance (for example minutes per kilometre). Speed = distance ÷ time (kilometres per hour). Time = pace × distance. Any of the three can be found from the other two, which is what a pace calculator does.

Worked example: 10 km in 55 minutes

Pace is 55 ÷ 10 = 5.5 minutes per km, which is 5:30 min/km. Speed is 10 ÷ (55 ÷ 60) = 10.91 km/h. In miles, multiply the per-km pace by 1.609: 8:51 min/mile. To check a plan, a 5:30 pace over 5 km gives 27:30.

Converting between kilometres and miles

One mile is 1.609344 km, so a per-mile pace is the per-km pace multiplied by 1.609 and a per-km pace is the per-mile pace divided by 1.609. For quick estimates, 5:00 per km is about 8:03 per mile, and 6:00 per km is about 9:39 per mile.

Predicting other race distances

The Riegel formula estimates a time at a new distance from a known result: T2 = T1 × (D2 ÷ D1)1.06. The exponent above 1 reflects that pace slows as distance grows. From a 10 km in 55:00, it predicts about 2:01:21 for a half marathon and about 4:13:01 for a marathon. Predictions assume similar training and conditions, and they tend to be optimistic for the marathon if your training has focused on shorter distances.

Using pace in training

  • Easy runs should feel comfortable enough to hold a conversation, often well slower than race pace.
  • Tempo runs are comfortably hard efforts, a little slower than 10K race pace.
  • Intervals are shorter repeats at or faster than race pace with recovery between.
  • Heart rate, effort and terrain matter as much as pace. Hills, heat and wind all slow you.

Pacing a race

Even or slightly negative splits (running the second half a little faster) usually give the best results. Starting too fast is the most common mistake and often costs far more time later than it gains early. Use the calculator to set split targets, such as the time you want at each kilometre or mile marker.

Common mistakes

  • Mixing up decimal minutes and minutes and seconds: 5.5 minutes is 5:30, not 5:50.
  • Using a pace from a flat track for a hilly course.
  • Assuming the Riegel prediction applies without specific training.
  • Comparing watch pace with course markers without accounting for GPS error.

Try these scenarios

DistanceTimePaceSpeed
5 km25:005:00 min/km12.00 km/h
10 km50:005:00 min/km12.00 km/h
Half marathon (21.0975 km)1:55:005:27 min/km11.01 km/h
Marathon (42.195 km)4:00:005:41 min/km10.55 km/h

Enter the distance in kilometres and the total time in minutes (for the half marathon, 115 minutes; for the marathon, 240). Note that holding 5:00 per km for 5 km is far easier than holding it for 42 km: pace targets must match the distance.

Frequently asked questions

What is a good running pace?

It depends on age, fitness and goals. Improvement relative to your own earlier performance is a more useful measure than comparison with others.

How do I convert 5.5 minutes to minutes and seconds?

The decimal part is a fraction of a minute: 0.5 × 60 = 30 seconds, so 5.5 minutes is 5:30.

How accurate are race predictions?

They are a guide for similar conditions and training. Use recent race results, not old ones, and treat longer-distance predictions as a ceiling for the first attempt.

Keep reading

This guide is general information, not medical advice, diagnosis or treatment. Talk to a qualified healthcare professional about your own situation. See our disclaimer.