Percentages Made Simple: Of, Change, Discounts, Markup and Margin

Last updated October 3, 2026 · How we calculate and check results

Percentages show up in prices, tips, test scores, interest and statistics. Almost every problem is one of a few patterns. Once you recognize the pattern, the calculation is two steps.

Open the Percentage Calculator

The three core questions

  • What is X% of Y? Multiply Y by X ÷ 100. 15% of 200 = 0.15 × 200 = 30.
  • X is what percent of Y? Divide X by Y and multiply by 100. 30 ÷ 120 × 100 = 25%.
  • What is the percent change from A to B? (B − A) ÷ A × 100. From 80 to 100: 20 ÷ 80 × 100 = +25%.

Why percent changes are not symmetrical

A price that rises from 80 to 100 has gone up 25%, but a fall from 100 back to 80 is a fall of 20%, because the base is now larger. The same logic means that a 10% gain followed by a 10% loss leaves you 1% down: 1.10 × 0.90 = 0.99. When comparing changes, always say which number the percentage is relative to.

Stacked discounts

Two successive discounts multiply; they do not add. A 20% discount followed by an extra 10% off is 0.80 × 0.90 = 0.72 of the original price, a total discount of 28%, not 30%. On a $150 item that is $108.00 rather than $105.00. The same rule applies to a sequence of price increases: 5% then 5% is 10.25%, not 10%.

Markup versus margin

Markup is profit as a percentage of cost, while margin is profit as a percentage of the selling price. If an item costs $60 and sells for $100, the profit is $40. Markup is 40 ÷ 60 = 66.7%, and margin is 40 ÷ 100 = 40%. People often confuse the two when setting prices. To reach a 40% margin from a cost of $60, you divide cost by (1 − 0.40): 60 ÷ 0.60 = $100, not 60 × 1.40 = $84.

Percentage points versus percent

If an interest rate rises from 4% to 5%, it has risen by 1 percentage point and by 25 percent relative to its old level. Headlines mix these constantly. When you read a statistic, check whether it describes an absolute gap or a relative change.

Reversing a percentage

To find the original price before a discount, divide by the remaining fraction. If a sale price is $72 after 28% off, the original was 72 ÷ 0.72 = $100. To remove 8% tax from a total, divide by 1.08, not multiply by 0.92. This "divide by the factor" rule undoes any percentage change.

Mental shortcuts

  • 10% is the number divided by 10. 1% is divided by 100.
  • 5% is half of 10%. 15% is 10% plus 5%. 20% is double 10%.
  • 25% is a quarter; 50% is a half; 75% is three quarters.
  • X% of Y equals Y% of X, so 8% of 50 is the same as 50% of 8 = 4. Use whichever is easier.

Common mistakes

  • Adding percentages that apply to different bases.
  • Calculating a decrease from the wrong baseline.
  • Confusing markup and margin.
  • Writing 0.05 where 5% is required (or the reverse) when entering values into a spreadsheet or calculator.

Frequently asked questions

How do I calculate a percentage increase?

Subtract the old value from the new one, divide by the old value, and multiply by 100.

How do I add a percentage to a number?

Multiply by (1 + percent ÷ 100). To add 15%, multiply by 1.15.

What is 15% tip on $48?

10% is $4.80 and 5% is $2.40, so 15% is $7.20.

Keep reading